Measuring a Slipper Spring

Step 2. Repeat the same from the end of the tail (B) to the centre bolt (D).

Step 3. Measure the camber (C - D).

PLEASE GIVE THE FOLLOWING MEASUREMENTS AS ACCURATELY AS POSSIBLE

1. Measurement of Leaf ________________ (A - D)

2. Measurement of Leaf ________________ (B - D)

3. Camber of Spring ___________________ (C - D)

4. Width of Spring _________________

5. Number of Leaves ____________

6. Steel Thickness _____________

7. Diameter of Shackle Pins __________

8. Grease Pins Yes / No

9. Front or Rear Spring ___________ (For Tandem only)

10. Diameter of Centre Bolt ___________

Please Note: All other leaves are measured the same as the Main Leaf.
The Main Leaf is always No. 1 or the longest leaf.
A - D and D - B is measured following the curve of the spring.
Tandem Spring assemblies centre bolt is usually offset (ie. not in the centre of the spring).

341 - 345 Port Road, HINDMARSH, SA 5007
Telephone: (08) 8346 2276 Fax: (08) 8340 1721
e-mail: sales@industrialsprings.com.au
www.industrialsprings.com.au